90% of the time when a sewing machine gets stuck it a) needs an oiling and be cleaned or b) there is thread somewhere where it shouldn't be. (the other 10% something is broken and needs replacing)
Today a LOT of thread decided to take a wrong turn and wrap itself tightly around the axle of the underthread thingy. I tried prying it out by removing the top plate and poking around with a seam ripper - which proved to be very hard. So I undid two more screws hoping it would give me more access to the part I was trying to reach. It didn't. Instead I spent about 3 hours trying to put the screws back in in the correct arrangement so my machine would sew again.
I them painstakingly removed all the thread (and found even more pieces of thread in there) gave it a good clean (which was long overdue) and oiled it.
I think my machine is up and running now, but the fear of having screwed (haha!) something up for good is real 
TIL do not remove too many screws (or at least try to find out what they are doing before you remove them).