Well that's your problem!
On the right is a new gear/cog for a 20+ year old garage door motor. On the left, is the one I had to replace because the cog had sheered off and ground its self into nothing.
On the right is a new gear/cog for a 20+ year old garage door motor. On the left, is the one I had to replace because the cog had sheered off and ground its self into nothing.
One of the primary uses for nylon gears in industrial equipment is to protect the other components of the system; the nylon gear will shear teeth before the other, far more expensive or complex components are damaged.
Not super relevant, just neat trivia.
If I were a world dictator I would harshly punish for plastic cogs. Steel is cheap. I doubt that there are more than a dozen cases where plastic cogs are actually better than metal ones.