is being a little back from the edge here okay or should i move it forward? i’m thinking about sparks vs. centre of mass for the bench.
@moira i would hold it in place with some clamps for a while and see how it goes before permanent mounting
here’s how this works basically I wind these bolts up above surface level then attach nuts to hold down whatever needs holding down
like this with the vise
@emily_rugburn yeh basically put these on the underside
the good thing is all the force of use is upwards for them which forces them if anything further into the wood, the vectors are all virtuous
despite that use a good glue because gravity still works and i didn’t and now i’m slowly gluing them when they get loose
@moira
errr,
me?
i'd like it closer to the edge if used for general duty.
As one may not know the size & shape of work to be put to the wheel, as it were.
more clearance in as many directions as one may will likely serve well.
Unless part of a fabrication process where all needed access is understood, more is better.
@cpm one of the things I’m wondering is whether it matters if the lip of the bench is behind the edge of the wheel housing or if being basically the same is equally as good
@moira you certainly don't want it much farther back, think about a long thing you need to grind the end of
unless you know your only use is for tiny things
i'm used to bench grinders that are big enough to have their own stand
asking because I could add two more retractable underside mounted bolts for temporary securement when using the grinder here but I want to have the correct position for them
#tools #workbench #BenchGrinder